Wave, selective, manual and repair soldering, dip soldering
Flux, alcohol-based
Di-carboxylic acids, synthetic resin complex, halogenide-free (WEEE/RoHS compliant) [OSP compatible]
Type ISO-9454: 1231 // DIN EN 61190-1-1: L0 (REL0)
| Appearance: | colourless to yellowish, clear liquid |
| Hazardous goods: | Yes |
| Solids content: | 2.0 wt.-% |
| Acid number: | 14 - 16 mg KOH/g |
| Halogenide-free: | Yes |
| Resinous: | Yes |
| Available as a concentrate: | No |
| Density at 20 °C: | 0.793 (+/- 0.003) g/ml |
| Flash point: | 12 °C |
| Durability: | 12 months |
This flux is very versatile in use and OSP-compatible. Good results have been achieved with manual-, wave- and selective soldering. The general rule, to apply as little flux as possible, is also applicable for this product.
Spray fluxing: With the dosing option quantify the flux, first set to 30 – 40 ml/min., observe the even distribution of flux on the circuit board (if necessary test with heatsensitive paper) and then adjust to the optimal quantity.
Preheating: With “simple” circuit boards a preheating temperature of 80 – 110 °C is recommended on the top side of the circuit board, with “more complex” boards from 100 – 130 °C. The flux can be used both in systems containing leades as well as those that are lead-free.
